RigAtlas
My builds

Power supply · MODEL NOTES

be quiet! Dark Power Pro 13 1600W (BN501)

A specialist power supply whose size and demand must both be justified

Check with my buildRead the specifications ↓
The decision

Dark Power Pro 13 1600W BN501 is a specialist choice for a configuration whose documented load and connectors justify very high output. It is difficult to justify from a generic desire for future-proofing alone. A smaller supply may make a conventional build easier to route and service; compare the actual installed requirement instead of treating maximum wattage or efficiency certification as a quality ranking.

Consider it when

  • An explicitly specified high-demand system with adequate case space and appropriate regional power arrangements.

Look again when

  • The hardware has modest requirements or the enclosure only allows a short PSU.

THE SPACE IT NEEDS

Leave room beyond the PSU body

200 mmBody length
Original dimension guide. The primary dimension is scaled; other geometry is schematic.
PSU body length
200mm

The body length excludes the working space needed for plugs and cable bends. Drive cages and the case layout can reduce that space.

Check power and cable requirements ↗

Based on the manufacturer specification record, checked . Check the exact revision and installation instructions before buying.

The checks that can change your choice

Verify the exact article, regional requirements and 200 mm body

The catalog identifies US article BN501 and a 200 × 150 × 86 mm enclosure. Confirm the purchased revision, input labeling, supplied mains cable and full GPU/EPS inventory from its manual. Capacity alone must not fill gaps in connector evidence or establish fit beside a drive cage.

Check the whole power path

Compare the CPU and exact graphics card requirements with the PSU capacity and included connector arrangement. Count independent cable runs where the GPU manual requires them. Use only cables approved for this exact power supply; similar-looking modular plugs do not establish compatible wiring.

Published specifications

1600 W; modular cables; 80 PLUS Titanium; current ATX 3.1 / PCIe 5.1 version; 200 × 150 × 86 mm.

Brandbe quiet!
Exact modelDark Power Pro 13 1600W (BN501)
Form factorATX
PSU rated output1600 W
PSU body length200 mm; cable connectors need additional space

Exact US article BN501. Confirm regional input and cable requirements. This high-output unit is intended for configurations whose actual power and connector requirements justify it.

Catalog record checked . Manufacturer specifications. The individual references below show the dates used for these model notes.

A different choice worth checking

be quiet! Straight Power 12 1200W (BN749)Straight Power 12 1200W BN749 is worth considering when the hardware genuinely needs its capacity and connector arrangement. For an ordinary single-GPU desktop it may be unnecessary compared with a smaller properly specified unit. Two 16-pin connectors are not permission to attach arbitrary graphics cards: their combined requirements, the rest of the system and the manufacturer’s cabling instructions still determine suitability.Read this model’s tradeoffs ↗CORSAIR RM1000x ATX 3.1 (CP-9020271-NA)RM1000x CP-9020271-NA is a useful comparison when a demanding build needs both substantial capacity and several separate conventional PCIe cable runs. It is not simply a larger RM750x: the inventory changes with wattage. Compare its four conventional runs with the shorter RM1000e arrangement, then decide which better matches the actual GPU, motherboard and enclosure rather than buying by series reputation alone.Read this model’s tradeoffs ↗Seasonic FOCUS GX-1000 ATX 3.1 v5FOCUS GX-1000 ATX 3.1 v5 is a candidate when the actual build needs 1000 W but the case benefits from a 140 mm ATX body. Compare its confirmed wiring against the RM1000x rather than assuming the higher wattage implies additional conventional cables. A clear connector plan and sufficient routing clearance are more useful than buying maximum capacity as an unspecified future-upgrade promise.Read this model’s tradeoffs ↗

These alternatives address related choices. Recheck their platform, connections and fit before treating one as a replacement.

Follow the check that matters to your build

Sources and review notes

RigAtlas connects manufacturer specifications to component choices. This page is document-based analysis; it does not claim a hands-on test or a current store offer.

How we use sources · Report a correction

See how it fits your list.

Review this component with your existing selections before making the change.

Check with my build