Check the parts that need to fit together.
A graphics card can be short enough and still need cable room. A cooler can fit until its fan meets the RAM. Start with the particular fit question, then bring the parts into your build when you are ready.
No account or complete parts list required. Your existing build stays unchanged until you confirm a transfer.
Which connection are you checking?
Compare the exact card length with the case limit. Add the cooler when a radiator or shared chamber may change the space.
Graphics card & case check
Choose the required models to see this check. Your build is unchanged.
These are checks of recorded dimensions and connectors, not a complete build certification. Exact revision, cable routing, mounting hardware and the installed layout still matter. Trying models here leaves your saved and working builds untouched.
A useful measurement has its conditions attached.
The tool uses the same documented rules as the RigAtlas builder. It compares recorded dimensions; it does not simulate a physical installation. Conditional case layouts, missing measurements, fan adjustments and uncertain connector details stay visible. A dimension difference is not a promise that the whole assembly fits.
Front USB-C results use separately researched exact-model cable and header evidence. A general specifications page, a rear USB-C port or a similar model name cannot establish that connection. Each source has its own recorded check date, and missing evidence is shown as unverified.
Open the manual with the right question.
- Check graphics-card clearance and cable room
- Check cooler height, RAM and raised fans
- Identify front-panel USB cables and motherboard headers
- Check CPU and motherboard support separately
How RigAtlas uses manufacturer evidence · Report an exact-model correction