BEFORE THE SIDE PANEL GOES ON

Check the parts that need to fit together.

A graphics card can be short enough and still need cable room. A cooler can fit until its fan meets the RAM. Start with the particular fit question, then bring the parts into your build when you are ready.

No account or complete parts list required. Your existing build stays unchanged until you confirm a transfer.

START WITH WHAT NEEDS TO FIT

Which connection are you checking?

Choose a fit check

Check the stock case’s front USB-C cable against the motherboard’s internal header. This does not check front USB-A, audio, adapters or rear USB-C ports.

Case Required

14 matching models. Use the exact case revision, including BASE, MAX or V2.

Motherboard Required

27 matching models. Rear USB-C ports do not establish an internal front-panel header.

Front USB-C & motherboard check

Choose the required models to see this check. Your build is unchanged.

These are checks of recorded dimensions and connectors, not a complete build certification. Exact revision, cable routing, mounting hardware and the installed layout still matter. Trying models here leaves your saved and working builds untouched.

A useful measurement has its conditions attached.

The tool uses the same documented rules as the RigAtlas builder. It compares recorded dimensions; it does not simulate a physical installation. Conditional case layouts, missing measurements, fan adjustments and uncertain connector details stay visible. A dimension difference is not a promise that the whole assembly fits.

Front USB-C results use separately researched exact-model cable and header evidence. A general specifications page, a rear USB-C port or a similar model name cannot establish that connection. Each source has its own recorded check date, and missing evidence is shown as unverified.

Open the manual with the right question.

How RigAtlas uses manufacturer evidence · Report an exact-model correction